Describes The Installation Steps Of The Toilet

1. Before installation, check whether the sewage pipe is unblocked and the installation floor is clean.

2. Install the matching sealing ring on the sewage outlet of the toilet.

3. Determine the installation position of the toilet. Slowly lower the toilet seat (drain) towards the pipe inlet, adjust the correct position, then (with chalk or whiteboard marker) draw marking lines around the toilet seat, and determine the mounting holes.

4. Punch mounting holes. Aim at the screws marking holes on the footing, drill the mounting holes with a hammer drill (diameter: 10mm, depth: 60mm), and load the expansion rubber nails. (Generally do not need to install the screws)

5. Put glass glue on the inside of the marking line.

6. Align the installation hole and the surrounding glass glue installed on the toilet, slowly press down until the level.

7. Sitting implement and ground connection place is hit on vitreous glue, ensure beautiful all round dressing.

8. Install the screws of the foundation.

9. Connect the water inlet pipe and check whether the filter is installed.

10. Clean the ground and tools, do not use immediately (glass glue curing generally needs 24 hours), keep the toilet around the water for 24 hours.